Flashers are the voice of an IR extender system that speaks to your components. IR Flashers: These IR MicroFlashers re-transmit the infrared signals from the IR Main System Unit to your A/V components.Sensors are also available in wall-mount, ceiling-mount and tabletop models.
Generally, sensors are placed so that you can easily and naturally point your remote control directly at them. IR Sensors: IR Sensors, like the included MS220 surface mount model, are the eyes of the system, receiving IR commands from hand-held remote controls and relaying the commands to the Main System Unit via a CAT-5 or a 4-conductor shielded cable.The Main System Unit is the heart of an IR extender system. IR Main System Unit: The MSU140 IR Main System Unit provides a connection hub for the IR sensor or keypads and up to four IR flashers, and it is generally located near the A/V components.IR System Components: This infrared extender system includes the following items: This enables you to place your A/V components out of sight (behind cabinet doors, in the rear of a room, or in a different room) and still conveniently control your equipment. IR System Overview: An infrared (IR) extender system enables you to control your IR remote controlled A/V equipment from a remote location. 50 feet of CAT-5 cable to connect the IR sensor to the IR hub.three MF1 flashers - Infrared light-emitting devices that carry IR commands from the MSU140 to your A/V gear.MSU140 IR hub - Accepts incoming IR signals and passes them on to your A/V components.It sends the IR commands from your remote control to the IR hub. MS220 IR sensor - Mount this small sensor in a convenient spot, like next to your TV.It includes everything you need to set up a complete IR (infrared) repeater system and control up to three A/V components: IR Repeater Block has size of 2.5in (L) x 2.He RCA-SM2 kit from Niles gives you easy control over your audio/video system, even if your gear is placed out of sight in a cabinet or closet.IR Receiver has size of 2.25in (L) x 0.5in (W) x 0.5in (H) 9ft cable is attached for connection to IR Repeater IR receiver has blue LED to confirm receipt of IR signal.The product team at C2G is working hard to find a solution for this issue At this time, the ATT U-Verse cable boxes are not compatible with the C2G, formerly Cables To Go, IR Receiver Kit. Since a plasma display emits IR frequencies during use, it may cause interference. Please Note: Careful consideration must be used when placing the IR receiver near a plasma display. You can use your existing remotes for simple installation and hookups. The IR receiver and IR repeater have blinking blue LEDs to confirm receipt of the IR signal the IR repeater is designed for mounting on shelf or wall. These emitters are connected from the repeater system and placed over the IR receiver of the equipment. The receiver has a 9 foot cable that is then attached to the repeater system that is mounted in your entertainment cabinet. With this kit, you may mount a receiver in a convenient place on or near your entertainment system.
0 kommentar(er)
